Connectors > Inline Pair

Deleting an Inline Pair

You can delete both halves of an inline pair simultaneously to rejoin any wires in the bundle.

Caution

Do not attempt to delete an inline pair using the Delete option, as this only removes the graphical representation of the connector from the diagram without re-joining the wires.

Procedure

Right-click over either half of the pair and click the Delete Inline Pair option; the system removes the inline pair from the bundle.

Results

Any wires in that bundle are re-joined.
If there is more than one bundle connected to either side of the inline, it is replaced with a structure node.
Any cavity that has multiple conductors connected to it (whether from the same or different bundles), or has no conductor at the mated pin, is replaced by a splice.
The two harnesses that were separated by the inline pair are merged into one harness. See Merging Harnesses for information about how the merge behavior is controlled and what happens during the merge operation.

Parent Topic:

Inline Pair