Applied

Constraints Report

You can generate (create) an HTML or csv report about the constraints that exist on objects in the currently open design.

Note

The report lists only those objects that have a constraint applied directly to them. For example, a connector with a constraint appears but its pins do not, even though they inherit constraints added to the connector.

The report is generated with the following columns:

• Harness Specifies the name of the harness to which the object belongs if appropriate.

• Object Name Specifies the name of the object.

• Object Type Specifies the type of object.

• Constraint Type Specifies whether the constraint is standard (STANDARD) or customized (CUSTOM).

• Constraint The constraint that exists on the object. If multiple constraints exist on an object, the object is listed multiple times. If a constraint was applied via a rule (that is, the rule was referenced rather than adding a constraint directly, then the entry in this column starts with the rule name and a colon. The evaluation mode used for any matching clauses is shown in parentheses (Regular expression, Wildcard expression, or String literal). See Selecting Evaluation Mode for Match Clauses. Figure 176: Section of Applied Constraint Report Showing Evaluation Mode in Parentheses

• Creating an Applied Constraints Report

Parent Topic:

Reports

Capital Systems Integrator User Guide, 2512.2606

Unpublished work. © 2026 Siemens