Adding a Specific Harness Connector as a Slot Connector to a Slot

You can add an unplaced harness connector (from an associated Capital Logic Designer design) as a slot connector to a slot. In the topology design, the slot represents the device to which the harness connector belongs and the slot connector represents the harness connector itself.

Prerequisites

• The Capital Logic Designer design containing the harness connector must be associated with the topology diagram. See Logical Design Association.

• The slot must contain the device to which the harness connector belongs. See Slots.

Procedure

1. In the Wiring Browser, navigate to the harness connector.

2. Double-click the connector and then click the edge of the slot to place the slot connector. A line is displayed across the cursor if the location is invalid.

Results

• The slot connector is added to the slot in the Diagram window.

• An association is created between the slot connector and the harness connector.

• The slot connector is added below the slot in the Design Browser (Capital Wiring Integrator).

• If a device connector is attached to a harness connector in the Capital Logic Designer design, a device connector is created as a separate object that is connected to the slot connector. The device connector is added to the Design Browser.

Parent Topic:

Slot Connectors

Related Topics

• Slot Connectors

• Adding an Unassociated Slot Connector to a Slot

• Editing a Slot Connector

• Specifying a Route Code for a Slot Connector

• Moving a Slot Connector

Capital Logic Designer User Guide, 2512

Unpublished work. © 2025 Siemens