Unhiding a Section of Harness

When you have hidden a section of harness using an insertion point, there are multiple ways you can unhide the content.

Note

The message area on the Status Bar, which runs along the bottom of the screen, displays instructional and dynamic tool tips relevant to the actions you are currently performing.

See “Status Bar Tool Tips” section of the Capital Formboard Manager User Interface

Prerequisites

• You have added an insertion point and hidden a section of a formboard.

Procedure

Select the node at which the required insertion point is located.

• Click the Unhide action on the Home ribbon. See “Insertion Point Ribbon Actions”.

• Right-click the node and select Insertion Point > Unhide.

• Use the Unhide manipulation handle, (see Manipulation Handles). Where there are multiple insertion points on same segment, if you unhide using this handle, all hidden content from all the insertion points becomes visible.

Results

• The hidden sections of the harness associated with this node are unhidden.

• The insertion point is not removed and can be used again.

Parent Topic:

Hide Pre-Assembled Content from Final Assembly Formboards

Capital Harness Designer User Guide, 2512

Unpublished work. © 2025 Siemens