Capital Wiring Integrator > Reports (Capital Wiring Integrator)

Applied Constraints Report

This reports on the constraints that have been set on objects in the currently active topology diagram. The report can be saved in HTML or CSV format.

The report lists only those objects that have a constraint applied directly to them. For example, a connector with a constraint will be listed but its pins will not, even though they inherit constraints added to the connector.

The report contains the following columns:

Harness Specifies the name of the harness to which the object belongs if appropriate.
Object Name Specifies the name of the object.
Object Type Specifies the type of object.
Constraint Type Specifies whether the constraint is standard (STANDARD) or customized (CUSTOM).
Constraint The constraint that has been applied to the object. If multiple constraints have been applied to an object, the object is listed multiple times. If a constraint was applied using a rule (that is, the rule was referenced rather than adding a constraint directly, the entry in this column starts with the rule name and a colon.

Parent Topic:

Reports (Capital Wiring Integrator)