Routing Assistant in 3D Electrical Design

The Routing Assistant is displayed as a tab in the Capital Output Window. It identifies possible routes for selected / identified unrouted wires and multicores. These routes may or may not be complete. If they are incomplete, the To-Do List table identifies where an inline connector instance is required in the associated Capital Logic Designer diagrams to complete the route. You can use the Routing Assistant to automatically insert a missing inline connector into the unrouted wires and multicores, so that they can be routed through the topology.

Full information about the Routing Assistant is provided in the Capital Wiring Integrator chapter of the Capital Logic Designer User Guide.

For information about the Routing Assistant interface, see Routing Assistant.

For information about using Routing Assistant with unrouted wires, see:

• Using the Routing Assistant to Identify the Possible Routes for One or More Unrouted Wires

• Using the Routing Assistant to Identify Unrouted Wires

• Routing Assistant Behavior for Different Combinations of Conductors

For information about using Routing Assistant with unrouted multicores, see:

• Using the Routing Assistant to Identify the Possible Routes for One or More Unrouted Multicores

• Recommended Paths for Partially Routed Multicores

• Routing of Multicores with Pigtail Wires

• Failure Cases for Split Multicore

Parent Topic:

Working in the 3D Electrical Context

3D Electrical Design User Guide, 2512.2606

Unpublished work. © 2026 Siemens