Configured Wire List Report

You can edit the XML configuration file in the reporter\templates\embedded sub‑folder of your Capital installation, to define the Configured Wire List report to specify which entries display on the wire list report.

You can generate a single report or a combination of reports for Capital Harness Designer, Capital Logic Designer, and Capital Systems Integrator. For each wire, any of the following information may be displayed:

• Type The type of report being generated. For Capital Logic Designer this is specified as “Logic”.

• Attribute This element displays the attribute value in the column title, for example “Name” - listing the name attributes of the wire.

• Property The property element displays the property value in the column title. for example “Signal” - listing the signal properties of the wire.

• Wireendexpressions This element contains all expressions listed below, that are applicable in a wire reports, as well as the start and end fields of the wire.

• Component The name of the component at which end 1 of the wire is terminated.

• Connector The connector at which end 1 of the wire is terminated.

• Pin The name of the Pin1 connector cavity at which end 1 of the wire is terminated. The pin element can have an additional attribute set; “mated” which means any mated pin option details applicable will be listed in the report.

• Component The name of the component at which end 2 of the wire is terminated.

• Connector The connector at which end 2 of the wire is terminated.

• Pin The name of the Pin2 connector cavity at which end 2 of the wire is terminated. The pin element can have an additional attribute set; “mated” which means any mated pin option details applicable will be listed in the report.

Parent Topic:

Available Reports

Capital Logic Designer User Guide, 2512

Unpublished work. © 2025 Siemens