Adding an

Unassociated Inline Pair to a Bundle

You can add an unassociated inline pair (inline plug connector and inline receptacle connector) to a bundle on a topology diagram.

Procedure

1. Press the space bar and enter Inline Pair.

2. In the Diagram window, hover over the bundle to place the inline pair.A line is displayed across the cursor if the location is invalid. A ghost image indicates how the inline pair graphic will look.

3. Click to place it.

Results

• The inline pair is added to the Diagram window.

• The harness to which it is added is split into two. The wires are unrouted and do not connect to the inline pair. The wires move to the Unrouted folder of the Design Browser (Capital Wiring Integrator). They are not considered routed until the inline pair is associated with an inline pair from a Capital Logic Designer design.

• The newly created harness is added to the Design Browser but contains no wires.

• The inline plug connector and inline receptacle connector are listed below the Inlines node of the Design Browser.

• The inline plug connector and inline receptacle connector are displayed below the harnesses to which they connect in the Design Browser.

Parent Topic:

Inline Pairs

Related Topics

• Inline Pairs

• Adding a Specific Logical Inline Pair to a Bundle

• Editing an Inline Plug Connector or an Inline Receptacle Connector

• Specifying a Route Code for an Inline Plug Connector or an Inline Receptacle Connector

• Moving an Inline Pair

• Deleting an Inline Pair from a Bundle

• Toggling the Inline Plug Connector and Inline Receptacle Connector on an Inline Pair

• Constraining the Automatic Association of Inline Halves

Capital Logic Designer User Guide, 2512

Unpublished work. © 2025 Siemens